Ghost Stageless TCT Connector (Slimline)

Offers a light 2.5 lb trigger pull reduction.

Eliminates the "wall" between the light takeup and heavier final creep. An Edge trigger becomes heavier sooner, but from there it is one long, smooth pull before the striker falls.

The Trigger control tab eliminates overtravel to shorten the reset.

It is designed to give a lighter and smoother trigger pull than factory.

This is accomplished by precise manufacturing processes and pre-polishing of the key contact points.

This is not a drop-in part. The trigger control tab needs to be shortened until the pistol fires reliably. When you first receive this connector, install it first before trimming/reducing. Apply extra pressure and see if it releases the firing pin. If it does, you will trim down very little to get a clean, smooth release.

Refer to the attached image indicating where to trim the tab. (Note that it is different than other Ghost connectors. If it doesn't release the firing pin, refer to Ghosts' instructions: CONNECTOR INSTALLATION INSTRUCTIONS - Ghost Inc

Fits Glock 43 / 43 / 43X / 48.

How it works.

The smoothed surfaces will reduce friction and allow for a smoother trigger action.

The adjusted release angle on the connector makes the trigger noticeably lighter at the cost of crispness. The angle on the Edge is significantly flatter, favouring consistency over crispness.

The trigger control tab presses against the trigger bar to limit overall travel. This tab needs to be shortened to work best with your particular pistol.