HBI Trigger Spring Kit (Scorpion)

Our spring kit provides a 5.5lb trigger pull (down from 9.0+ lbs factory trigger). Simply remove your factory trigger and disconnector springs and replace them with our application specific trigger and disconnector springs. Both springs in our kit must be used together. Gunsmith installation is recommended, but not required.

On some Scorpions the sheet metal trigger housing are slightly warped, allowing the firing pin safety lever to rub on the side of the housing. If you find this to be the case with your Scorpion, the kit includes a shim to add a little bit of space allowing free movement of the lever.

TIP: Many customers opt to also deburr and polish the working surfaces of the trigger components while replacing these springs; doing so will typically result in an even lower trigger pull weight and smoother trigger operation.

Includes:

• Trigger Spring
• Disconnector Spring
• Firing Pin Safety Shim

Note that some older Scorpions have welded trigger packs that require drilling to disassemble. See HBI Welded Trigger Pack Drill for more information.