Manufacturers

    IPSC rigs (Shadow)

    DAA Alpha-X Colour Inlay (Pouch) View larger

    DAA Alpha-X Colour Inlay (Pouch)

    New product

    Coloured inlay for Double Alpha Alpha-X Magazine Pouch

    More details

    R75.00 tax incl.

    More info

    This is a complete set of Alpha-X Pouch Inlays for one magazine pouch in the colour of your choice.

    Includes left, right and side inlays. Depending on where you mount the ball joint attachment, one inlay part will not be used.

    Please note that these inlays have a protective transparent film on their front and 3m adhesive tape cover on their back. both should be peeled off before installation.

    Should you wish you remove the inlays after installation, you can do so thanks to the small holes drilled through the pouch body. In order to access these holes, you will need to remove all plastic spacers first. Then, using a sharp tool (like a small hex key) you can push on the inside of the inlay until it comes loose in the corner. Then, gently work it out of its pocket. Note that the inlay may break when removed.

    Installation instructions:

    • Carefully break the pieces out of their frame. There are several small bridges holding them in place which can be broken by hand.
    • If you wish, you can use a knife to clean off the tails left by the bridges, but this should not be strictly necessary.
    • Peel off the transparent film from the front, as well as the 3M adhesive cover from the back.
    • Position the inlays over their correct pockets in the pouch body and fit them in place.